Myujth

In an SO question I answered these two sed lines:

• 
  

  First:

  
  
  

  sed -e "1,$(expr $(sed -n '/^delay=/=' your_file.txt | tail -1) - 1)"'s/^delay=.*$//' 
   -e 's/^delay=/ens_delay=/' your_file.txt
  

  
  


• 
  

  Second:

  
  
  

  sed -e "1,$(expr $(sed -n '/^delay=/=' your_file.txt | tail -1) - 1)"'/^delay=.*$/d' 
   -e 's/^delay=/ens_delay=/' your_file.txt
  

  
  

In the second line, I figured out I needed curly braces around /^delay=.*$/d to make it work. But it wasn't necessary for s/^delay=.*$// in the first line (though it works with).

Why this difference?

DISCLAIMER: The answer is a trimmed copy of Why are these curly braces necessary in sed?

Per the POSIX standard's page on sed:

The script shall consist of editing commands of the following form:

[address[,address]]function

where function represents a single-character command verb from the list in
Editing Commands in sed, followed by any applicable arguments.

So the first non-blank character after the address is taken as a command verb.

The braces are referenced further down:

[2addr] editing command
editing command
...

Execute a list of `sed` editing commands only when the pattern space is selected.  …

^{[2addr] is an indicator that the maximum number of permissible addresses is two.}

To clarify a point made above, the Addresses section of sed(1) says:

Sed commands can be given with no addresses,
in which case the command will be executed for all input lines;
with one address, in which case the command will be executed only
for input lines which match that address;
or with two addresses, in which case the command will be executed
for all input lines which match the inclusive range of lines
starting from the first address and continuing to the second address. 
Three things to note about address ranges:
the syntax is addr1,addr2 (i.e., the addresses are separated by a comma);

        … (and other stuff not relevant to this discussion) …

The gnu info page (info sed) has a similar description of and ,
under "3.4 Often-Used Commands":

 COMMANDS 

A group of commands may be enclosed
between and characters.
This is particularly useful when you want a group of commands to be triggered
by a single address (or address-range) match.

Otherwise said, braces are used to apply multiple commands at the same address or to nest addresses.

The standard isn't very explicit here¹ but the left brace is actually a command that starts a group of other sed commands (the group ends with a right brace ).

1:

though if you read the entire page it is mentioned that:
Command verbs other than {, a, b, c, i, r, t, w, :, and # can be followed by...